Maintaining Your
MAINTENANCE
WARNING: For your own safety, push control knob “OFF” and remove plug from power source outlet before maintainingor lubricatingyour saw.
General
An occasional coat of paste wax on the work table will allow the wood being cut to glide smoothly across the work surface.
Motor
If the power cord is worn, cut or damaged in any way, have it replacedimmediately.
Do not attempt to oil the motor bearings or service the motor internal parts.
Arm Bearings
Lubricate the arm bearings after 10 hours of use.
0
n
METHOD OF OILING BEARINGS
1.Turn saw on its side.
2.Squirt a generous amount of SAE20 Oil around the shaft end and bronze bearing.
3.Let the oil soak in overnight in this position.
4.Next day repeat the above procedure for the opposite side of the saw.
WIRING DIAGRAM
15