Assembly dk Adjusting
ADJUSTING HOLD DOWN
The hold down should be adjustedso it contacts the top surface of the work being cut by loosening adjusting knob and moving hold down rod up or down. Tighten adjusting knob after adjustment has been made.
ADJUSTING DUST BLOWER
The dust blower may be moved to direct air to the most effective point on the cutting line by loosening screw, adjust dust blower accordingly and tighten screw.
Hold Down Rod
Lock Knob
Blade support &
Guard Set Screw
Blade support & Guard
Sawdust Blower
Set Screw
Sawdust Blower
ALIGNING THE BEVEL INDICATOR
1.Loosening the hold down adjusting knob and moving hold down rod up. Then tighten adjusting knob.
2.Loosen the table lock knob and move the table until it is approximately perpendicular, or at a right angle to the blade.
3.Place a small square on the table next to the
blade to check if the table is 90 degrees to the blade. If adjustment is needed, raise or lower the table until table is approximately 90 degrees to the blade and securely tighten the table lock knob.
4.Loosen the screw holdingthe degree scale pointer, move pointer to the 0 degree mark and
securely tighten screw. Remember, the degree | D W r m |
scale is a convenient guide but should not be |
|
relied upon for precision. Make practice cuts |
|
on scrap wood to determine if your angle |
|
setting are correct. |
|
5.Remove the hold down rod to desired position.
9