Friedrich SV08A10, SV12A10, SV10A10 manual Capacitor, Power Cord, Thermostat, Rotary Switch

2.3.3 CAPACITOR

1. Remove the cabinet. (Refer to section 2.1.2)

2. Remove the screw and the clamp which fastens the capacitor.

3. Disconnect all the leads of capacitor terminals.

4. Re-install the components by referring to the removal procedure, above. (See Figure 11)

Tem
perat
ure	Med
Warmer
	Fan	Off
Cooler				High
	Low			Cool
	Fan
		Low	Cool	Med
				Cool

Mode

Figure 11

2.3.4 POWER CORD

1.Remove the cabinet. (Refer to section 2.1.2)

2.Disconnect the grounding screw from the control box.

3.Disconnect the 2 receptacles.

4.Remove a screw which fastens the clip cord. (See Figure 12)

5.Remove the power cord.

6.Re-install the component by referring to the above removal procedure, above.

(Use only one ground-marked hole	for ground
connection.)

7.If the supply cord of this appliance is damaged, it must be replaced by the special cord. (The special cord means the cord which has the same specification marked on the supply cord attached at the unit.)

2.3.5 THERMOSTAT

1.Remove the cabinet. (Refer to section 2.1.2)

2.Remove the 2 screws which fasten the thermostat.

3.Disconnect 2 leads of thermostat terminals.

4.Remove the thermostat.

5.Re-install the components by refering to the above removal procedure. (See Figure 13)

2.3.6 ROTARY SWITCH

1.Remove the cabinet. (Refer to section 2.1.2)

2.Remove the 2 screws which fasten the rotary switch.

3.Disconnect all the leads of the rotary switch terminals.

4.Remove the rotary switch.

5.Re-install the components by referring to the above removal procedure. (See Figure 14)

Figure 12

Figure 13

Figure 14

— 8—