
3 Installing a Brocade
2.Lift the cord retainer and connect an AC power cord to the associated power supply AC Inlet, as shown in Figure 122.
3.Snap the
FIGURE 122 Connecting a power cord to the power supply in a Brocade MLX-8 router
1
2
3
4
1 | Lift handle | 3 | Power cord |
2 | Cord retainer | 4 | Ground point |
DANGER
If the installation requires a different power cord than the one supplied with the device, make sure you use a power cord displaying the mark of the safety agency that defines the regulations for power cords in your country. The mark is your assurance that the power cord can be used safely with the router.
For information about powering on the system, refer to “Activating the power source” on page 228.
Connecting DC power
You can provide DC power for the Brocade
DANGER
The procedure in this section is for qualified service personnel.
172 | Brocade MLX Series and Brocade NetIron XMR Hardware Installation |