Installing a Brocade NetIron XMR 16000 router | 4 |
DANGER
If the installation requires a different power cord than the one supplied with the router, make sure you use a power cord displaying the mark of the safety agency that defines the regulations for power cords in your country. The mark is your assurance that the power cord can be used safely with the router.
Connecting DC power
You can use a DC power for the Brocade NetIron XMR 16000router by installing a
DANGER
The procedure in this section is for qualified service personnel.
Follow these steps to connect a DC power source.
1.Use a #1 Phillips screwdriver to remove the two screws that hold the transparent cover over the power supply lugs, as shown in Figure 189.
FIGURE 189 The Brocade NetIron XMR 16000 DC power supply
2
IN DC OUT
1
1 Screws holding transparent cover 2 Screws holding power lugs
2.Remove the transparent plastic cover.
3.Use a #2 Phillips screwdriver to remove the power lugs, as shown in Figure 189.
4.Crimp the correct AWG wire into the power lugs and reconnect the lugs to the power supply unit:
For 1200 W power supply, crimp #8 AWG For 1800 W power supply, crimp #6 AWG
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide | 271 |
|
|
