1 Router modules
SYSLOG: May 28 16:22:35:<13>May 28 16:22:35 System: Module was inserted to slot 7 Module 7 is
Reset slot 7
SYSLOG: May 28 16:22:48 :<13>May 28 16:22:48 Module 7 is reset by mgmt (reason: boot to interactive mode)
Power supply requirements for
Table 14 lists the power supply requirements for each type of router when installing
TABLE 14 Power supply requirements for
Router type | Number of | Power supply requirements |
|
| |
| interface modules |
|
| installed |
|
|
|
|
three | one 1200W PSU | |
|
| for 1+1 redundancy, install two 1200W PSU |
|
|
|
| four | two 1200W PSU |
|
| for 2+2 redundancy, install four 1200W PSU |
|
|
|
four | one 1200W PSU | |
Brocade NetIron |
| for 1+1 redundancy, install two 1200W PSU |
XMR 4000 |
|
|
|
|
|
seven | two 1200W PSU | |
|
| for 2+2 redundancy, install four 1200W PSU |
|
|
|
| eight | three 1200W PSU |
|
| for 3+1 redundancy, install four 1200W PSU |
|
|
|
Brocade NetIron | eight | two 1200W PSU |
XMR 8000 |
| for 2+2 redundancy, install eight 1200W PSU |
|
|
|
All | sixteen | four 1200W PSU |
|
| for 4+4 redundancy, install eight 1200W PSU |
|
|
|
All | four 2400W PSU | |
|
| for 4+4 redundancy, install eight 2400W PSU |
|
|
|
24-port 1 Gbps Ethernet copper RJ45 interface module
The
•
•
This module has 32 Mb of flash memory and contains 24 RJ45 physical ports, through which you can connect your router to other network routers.
36 | Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide |
|
