Router modules | 1 |
NOTE
When you are replacing older modules with 24x1G modules, you must first delete the software configuration for the older module. If you do not delete the old configuration, a configuration mismatch will occur when you install the new module. This mismatch will be displayed in the results of the show config command.
NOTE
The SNMP Management Information Base (MIB) uses the Interface Index (ifIndex) to assign a unique value to each port on a module or slot. The number of indexes that can be assigned per module is 20, 40, or 64, depending on the number of ports on the module. When installing
Figure 22 shows the front panel of the BR-MLX-1GFx24-X and BR-MLX-1GFx24-X-ML fiber interface modules.
FIGURE 22 BR-MLX-1GFx24-X and BR-MLX-1GFx24-X-ML fiber interface module front panel
The front panel includes the following features:
•Arrow-shaped LEDs in center horizontal strip for all ports. LEDs to the left support the bottom ports, LEDs to the right (pointing up) support the top ports.
•24 1 Gbps fiber ports
Table 17 describes the LEDs for the BR-MLX-1GFx24-X and BR-MLX-1GFx24-X interface modules.
TABLE 17 |
| |||
|
|
|
| |
Position |
| State | Meaning | |
|
|
| ||
Solid green | A link has been established. | |||
horizontal strip between ports. |
|
| ||
Green blinking | The port is transmitting and receiving packets. | |||
Left LEDs support upper ports. | ||||
|
| |||
Right LEDs support lower ports. | Off | No link exists, and the port is not transmitting or receiving | ||
|
|
| packets. | |
|
|
|
| |
For a list of SFP optics supported for the
http://www.brocade.com/downloads/documents/data_sheets/product_data_sheets/Optics_DS.p df
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide | 39 |
|
