Brocade Communications Systems 53-1002373-02 manual 8x10GE-X interface module LEDs

1 Router modules

8x10GE-X interface module LEDs

The 8x10GE-X interface module LEDs indicate module and port status, as described in Table 7.

TABLE 7	8x10GE-Xmodule LEDs
LED	Location	State	Meaning
Power	Lower left corner of module	Green	Module is receiving power
		Off	Module is not receiving power
Link/Act	Below the ports. Top port	Green	Port enabled and link is passing traffic. LED is solid
	LED on left, bottom port LED	blinking	green when link is idle.
	on right.
		Off	Port is disabled.

Power supply requirements for 8x10GE-X modules

Table 8 lists the power supply requirements for each type of router when installing 8x10GE-X modules.

TABLE 8 Power supply requirements for 8x10GE-X modules

Router type	Number of 8x10GE-X	Power supply requirements
	modules installed
MLXe-4	one	one 1200W PSU
		for 1+1 redundancy, install two 1200W PSU
	two to four	two 1200W PSU
		for 2+2 redundancy, install four 1200W PSU
		one 1800W PSU
		for 1+1 redundancy, install two 1800W PSU
MLX-4 and	four	one 1200W PSU
Brocade NetIron		for 1+1 redundancy, install two 1200W PSU
XMR 4000
MLXe-8 and	seven	two 1200W PSU
Brocade NetIron		for 2+2 redundancy, install four 1200W PSU
XMR 8000
	eight	three 1200W PSU
		for 3+1 redundancy, install four 1200W PSU
		two 1800W PSU
		for 2+3 redundancy, install four 1800W PSU
All 16-slot routers	fifteen	four 1200W PSU
		for 4+4 redundancy, install eight 1200W PSU
	sixteen	five 1200W PSU
		for 5+3 redundancy, install eight 1200W PSU
		four 1800W PSU
		for 4+4 redundancy, install eight 1800W PSU
All 32-slot routers	twenty-eight	four 2400W PSU
		for 4+4 redundancy, install eight 2400W PSU
	twenty-nine to	five 2400W PSU
	thirty-two	for 4+4 redundancy, install eight 2400W PSU
		four 3000W PSU
		for 4+4 redundancy, install 3000W PSU

28	Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
	53-1002373-02