Brocade Communications Systems 53-1002373-02 manual 8x10GE-X interface modules

Router modules 1

TABLE 6 Power supply requirements for 100xGbE modules (Continued)

Router type	Number of 100xGbE	Power supply requirements (minimum required-redundancy requirements)
	modules installed
MLXe-16	six	four 1200W PSU
		for 4+4 redundancy, install eight 1200W PSU
		for 3+3 redundancy, install four 1800W PSU
	seven to eight	a minimum of five 1200W PSU
		for 4+4 redundancy, install eight 1800W PSU
		for 5+3 redundancy, install eight 1200W PSU
Brocade NetIron	eight (1x100GE)	four 1200W PSU
XMR 1600		for 4+4 redundancy, install eight 1200W PSU
MLXe-32	twelve	four 2400W PSU
		for 4+4 redundancy, install eight 2400W PSU
	thirteen to sixteen	five 2400W PSU
		for 5+3 redundancy, install eight 2400W PSU
		four 3000W PSU
		for 4x4 redundancy, instal eight 3000W PSU
Brocade NetIron	sixteen (1x100GE)	four 2400W PSU
XMR 3200		for 4+4 redundancy, install eight 2400W PSU

8x10GE-X interface modules

The 8x10GE-X interface modules provide 8 ports of 10 Gigabit Ethernet with support for 1M IPv4 routes in hardware.

NOTE

Gen-2 8x10GE-X modules require high speed switch fabric modules to operate. You can replace switch fabric modules with high-speed switch fabric modules while the system is powered on and running. For more information about high-speed switch fabric modules, refer to “High-speed switch fabric modules” on page 50.

Figure 16 shows the faceplate of the 8x10GE-X module.

FIGURE 16 8x10GE-X module faceplate

1

2

7

8

8x10GE-X modules support SFP+ optics only; they do not support SFP or CFP optics. For a list of supported SFP+ optics, refer to the latest version of the Brocade Optics Family Data Sheet, available online in the following location:

http://www.brocade.com/downloads/documents/data_sheets/product_data_sheets/Optics_DS.p df

Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide	27
53-1002373-02