Brocade Communications Systems 53-1002373-02 manual Connecting DC power

4 Installing a Brocade NetIron XMR 4000 router

FIGURE 173 Connecting a power cord to the power supply in a Brocade NetIron XMR 4000 router

3

2

1

1 Ground point 3 Cord retainer

2 Power cord

DANGER

If the installation requires a different power cord than the one supplied with the router, make sure you use a power cord displaying the mark of the safety agency that defines the regulations for power cords in your country. The mark is your assurance that the power cord can be used safely with the router.

4.For information about powering on the system, refer to “Activating the power source” on page 297.

Connecting DC power

You can provide DC power for the Brocade NetIron XMR 4000 router using a DC-to-DC power supply. DC power must be supplied at 48 V and 40 A. The DC-to-DC supply provides the DC power to the router at 12 V and 100 A.

DANGER

The procedure in this section is for qualified service personnel.

250	Brocade MLX Series and NetIron XMR Hardware Installation Guide
	53-1002373-02