Installing a Brocade | 2 |
FIGURE 49 Installing a power supply
4.Push the power supply front panel into the router until it engages the backplane connector.
5.Pull the latch handle on the power supply up to lock the power supply in place.
For information about connecting power to the router, refer to “Connecting AC power” on page 77 or “Connecting DC power” on page 78.
Connecting AC power
AC power is supplied through a power cord connected to the AC power supply installed in the router.
NOTE
For the
Follow these steps to connect the AC power cord.
1.Locate the power supply AC inlet on rear of chassis for the associated installed power supply.
2.Lift the cord retainer and connect the AC power cord to the AC inlet.
3.Snap the cord retainer over the power plug to hold it in place.
DANGER
If the installation requires a different power cord than the one supplied with the router, make sure you use a power cord displaying the mark of the safety agency that defines the regulations for power cords in your country. The mark is your assurance that the power cord can be used safely with the router.
For information about powering on the system, refer to “Activating the power source” on page 141.
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide | 77 |
|
|
