Brocade Communications Systems 53-1002373-02 manual Final steps

4 Installing a Brocade NetIron XMR 16000 router

CAUTION

For the NEBS-compliant installation of Brocade NetIron XMR 4000, 8000, and 16000 routers with AC and DC systems, use a ground wire of at least 6 American Wire Gauge (AWG). The ground wire should have an agency-approved crimped connector (provided with the device) attached to one end, with the other end attached to building ground. The connector must be crimped with the proper tool, allowing it to be connected to both ground screws on the enclosure. Before crimping the ground wire into the provided ground lug, insure the bare copper wire has been cleaned and antioxidant is applied to the bare wire.

CAUTION

To ensure adequate bonding when attaching the ground lug, a minimum of 20 PSI of torque is required to be applied to the mounting hardware used to attach the ground lug.

FIGURE 190 Crimping the power supply wire in the lug

1

1AWG power supply wire

For 1200 W power supply, #8 AWG For 1800 W power supply, #6 AWG

5.Connect the -48V cable to the negative terminal and the 0V cable to the positive terminal as marked on the power supply.

NOTE

DC return must be isolated from the device ground (DC-I) when connecting to the power supply.

6.Replace the transparent plastic cover and screws.

This equipment installation must meet NEC/CEC code requirements. Consult local authorities for regulations

Final steps

Follow these steps to complete the installation:

•“Attaching a management station”

•“Activating the power source”

•“Verifying proper operation”

272	Brocade MLX Series and NetIron XMR Hardware Installation Guide
	53-1002373-02