Enabling and disabling management module CPU usage calculations | 7 |
Brocade#
To
Brocade#
In this output example, there is one interface module in slot 3 and slot 3 is powered on.
Brocade#
rw_power_on_lp: write 00070004 to RW_MBRIDGE_CARD_POWER_OFF_REG
Syntax: power-on lp [<slot-number> all]
•The
•The all parameter allows you to power on all interface modules.
Enabling and disabling management module CPU usage calculations
You can enable the router to perform usage averaging calculations on tasks handled by CPU on the management module. You can then display usage averages for all tasks performed by the CPU on the management module for an interval of up to one hour. You can display these statistics using the show cpu command.
NOTE
Typically, these statistics are used for debugging purposes.
By default, the performance of the calculations is disabled. When disabled, you can use the show cpu command without optional parameters to display usage averages for all tasks performed by CPU on the management module.
NOTE
The
To enable the usage averaging calculations, enter the following command at the global CONFIG level of the CLI.
Brocade(config)#
Syntax: cpu-usage on
To disable the usage averaging calculations, enter the following command at the global CONFIG level of the CLI.
Brocade(config)#
Syntax: cpu-usage off
NOTE
When you are finished gathering statistics for debugging purposes, it is recommended that you disable the usage averaging calculations, which are
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide | 345 |
|
|
