![](/images/new-backgrounds/1109210/109210825x1.webp)
| Appendix | |
Brocade MLXe Chassis bundles | A | |
|
|
|
The following conditions must be met for any chassis with a MR2 management module to operate properly:
•The MR2 module requires a minimum software version of R05.2.00b to operate. Do not attempt to downgrade the MR2 module to a release lower than R05.2.00b.
•
•MR and MR2 modules cannot be mixed together in any MLXe, MLX, XMR chassis
•Do not downgrade the MBRIDGE version on the MR2 module.
•The MR2 management module requires MBRIDGE version 36 or later for
•The MR2 management module requires MBRIDGE32 version 35 or later for
•In certain module combinations, you will need to make sure the supported software is loaded.
The following software requirements must be met for any chassis bundle to operate properly:
•All Brocade
•All Brocade
•In certain module combinations, you will need to make sure the supported software is loaded.
NOTE
In certain module combinations, a Brocade MLXe system may not have enough power supplies to support the configuration. Check the power specifications for the MLXe chassis and the modules in the “Hardware Specifications” chapter of the installation guide to determine if an additional power supply is required. Additional power supplies can be ordered through Brocade.
For additional information on upgrade procedures, refer to the
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide | 395 |
|
|