Installing a Brocade NetIron XMR 16000 router | 4 |
Installing a Brocade NetIron XMR 16000 router in a rack
Keep the following precautions in mind when installing a Brocade NetIron XMR 16000 router in a rack:
DANGER
A
DANGER
Do not use the handles on the power supply units to lift or carry routers.
DANGER
Make sure the rack or cabinet housing the router is adequately secured to prevent it from becoming unstable or falling over.
DANGER
Mount the router in a rack or cabinet as close to the floor as possible. Place the heaviest router at the bottom and progressively place lighter routers above.
Because of the weight of a fully loaded Brocade NetIron XMR 16000 router, it is recommended that you mount it in a rack before installing modules and AC power supplies.
You can install up to three Brocade NetIron XMR 16000 routers in a standard
You must provide four standard
Follow these steps to mount a Brocade NetIron XMR 16000 router in a rack.
1.Determine the position of each router in the rack. For example, mount a router with the fewest modules near the top, a router with more modules near the middle, and a fully populated router near the bottom of the rack.
2.Position the four mounting screws for each router in the rack posts according to the spacings of the keyhole slots (the ones with the narrow portion pointing up) on the mounting brackets as shown in Figure 184. When tightening the screws, leave approximately 1/4 inch clearance between the back of the screw head and the rack post.
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide | 263 |
|
|
