
7 Managing switch fabric modules
Forcing HSF modules to operate in normal mode
NOTE
This procedure requires that you restart your router.
If necessary, you can configure HSF modules to operate in normal mode using the
Brocade(config)#
Syntax: [no] system-init fabric-date-mode force-normal
If you remove the forced normal condition using the no version of this command, you must enter the
Blocking discovery of G1 switch fabric modules
NOTE
This procedure requires that you restart your router.
In a router with both standard (G1) switch fabric modules and G2 HSF modules, you can block the discovery of the G1 switch fabric modules by entering the
Syntax:
After you enter this command, enter the write
330 | Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide |
|
|