Brocade Communications Systems 53-1002373-02 manual Accessing modules for service

Installing a Brocade NetIron XMR 32000 router 4

FIGURE 203 Routing lower-right quadrant cables

1

			2
			3
			4
1	Lower right quadrant	3	Comb B (slots #27 and #28 cables)
2	Comb A (slots #29 and #30 cables)	4	Comb C (slots #25 and #26 cables)

2.Route cables from slots #30 and #29 down through comb A. Refer to Figure 203.

3.Route cables from slots #28 and #27 down through comb B.

4.Route cables from slots #26 and #25 down through comb C.

Accessing modules for service

With the cables bundled correctly, it is easier to access the modules for service. Gently move the cable bundles to the side to access a module. Use the appropriate Phillips or flat-blade screwdriver with an extended shaft to disconnect the cables from the module and remove the module. There is no need to undo the cable cinches or cable ties. Refer to Figure .

NOTE

This procedure is easier with two people. One person can hold the cable bundles aside while the other person loosens the connectors and removes the module.

Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide	289
53-1002373-02