Installing a Brocade NetIron XMR 4000 router | 4 |
Although slot blanks differ in size, the procedure for removing them is the same. The procedure in this section applies to all slot blanks. You will need a
Follow these steps to remove a slot blank:
1.Loosen the screws on each end of the slot blank by hand or with a
2.Pull the slot blank out of the router, and store it in a safe place for future use.
Before installing modules in the Brocade NetIron XMR 4000 router, have these items available:
•A large flat blade screwdriver.
•An ESD wrist strap with a plug for connection to the ESD connector on the router.
DANGER
For safety reasons, the ESD wrist strap should contain a 1 megohm series resistor.
Although slot blanks differ in size, the procedure for removing them is the same. The procedure in this section applies to all slot blanks. You will need a
CAUTION
If you do not install a module in a slot, you must keep the slot blank in place. If you run the router with an uncovered slot, it may overheat. Tighten the screws that secure the slot blanks so that they remain in place when removing adjacent panels or modules.
Follow these steps to remove a slot blank.
1.Loosen the screws on each end of the slot blank by hand or with a
2.Pull the slot blank out of the router, and store it in a safe place for future use.
CAUTION
If you are
Follow these steps to install a module in the Brocade NetIron XMR 4000 router.
1.Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector on the router chassis.
2.Remove the module from the packaging.
3.With the ejectors in the outward position, insert the module into the appropriate slot (refer to Table 40) and slide the card along the card guide until the ejectors on either side of the module rotate towards the module faceplate.
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide | 247 |
|
|
