
Replacing fan assemblies | 8 |
Replacing the fan tray assembly in 4-slot and 8-slot routers
The fan tray assembly on Brocade MLX and Brocade NetIron XMR
You can remove and replace a fan tray assembly while the router is powered on and running. To replace a fan tray assembly, have these items available:
•A new fan tray assembly, which you can order from Brocade.
•An ESD wrist strap with a plug for connection to the ESD connector on the router.
DANGER
For safety reasons, the ESD wrist strap should contain a 1 megohm series resistor.
NOTE
If you did not remove the extra shipment screws from the router during installation, you will not be able to remove the fan tray assembly. You will need to remove the router from the rack to remove the shipping screws, (refer to the installation chapter appropriate for your router model) before you can remove the fan tray assembly.
Follow these steps to replace fan tray assemblies in
1.Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector on the router.
2.To remove the fan tray assembly from the router, push down on the latch release with your thumb, grasp the handle, and pull it toward you as shown in Figure 235, Figure 236, Figure 237 and Figure 238. Pulling the assembly unseats the fan tray assembly connector from a router connector.
DANGER
Be careful not to insert your fingers into the fan while removing it. The fan may still be spinning at a high speed.
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide | 365 |
|
|