
Installing a Brocade | 2 |
Connecting AC power
AC power is supplied through the power cord that is connected to the AC power supply in the router.
NOTE
For the
Follow these steps to connect the AC power cord.
1.Locate the AC inlet on rear of chassis for the associated installed AC power supply.
2.Lift the
3.Snap the
DANGER
If the installation requires a different power cord than the one supplied with the router, make sure you use a power cord displaying the mark of the safety agency that defines the regulations for power cords in your country. The mark is your assurance that the power cord can be used safely with the router.
For information about powering on the system, refer to “Activating the power source” on page 141.
Connecting DC power
You can provide DC power for the router by installing a
DANGER
The procedure in this section is for qualified service personnel.
NOTE
Because there are multiple power supply vendors, the LED layout on your DC power supply may differ from what is shown in Figure 56. However, the LED functions are identical.
Follow these steps to connect a DC power source.
1.Use a #1 Phillips screwdriver to remove the two screws that hold the transparent cover over the power supply lugs, as shown in Figure 56.
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide | 87 |
|
|