MAINTENANCE
CAUTION :
Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace when they wear down to about 4.5 mm (3/16") or less. Keep the brushes clean and free to slip in the holders. Both brushes should be changed a t the same time, Use only Makita carbon brushes.
,...-
U
4.5" (3/16")
Fig. 18
Use a screwdriver to remove the brush holder cap as shown in the figure.
Fig. 19
Take out the worn brush, insert the new one and secure the brush holder cap.
II
Fig. 20
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Center, always using Makita replacement parts.
11