Makita JV2000 instruction manual Bevel cutting, Finishing edges

Page 8

Bevel cutting

1 . With the base tilted, you can make bevel cuts a t any angle between 0" and 45" (left to right).

2.Loosen the bolt on the back of the base with the hex wrench. Tilt the base to the desired angle. The edge of the hous- ing indicates the bevel angle. (Fig. I O ) . Then check for contact between the back edge of the blade and the roler.

Now tighten the bolt securely on the back of the base.

I

Finishing edges

To trim edges or make dimensional adjust. ments, run the blade lightly along the cut edges.

For smoother cutting of plywoods or other materials with easily splintered surfaces, the wood may be coated or transparent tape used over your cutting line.

I

Fig. 9

Roller 1 Edge of housing

1Fig. I (

7

Fig. 1 1

8

Image 8
Contents Model Jvzooo SPEC1FICATIONSSafety Instructions Page Additional Safety Rules HOW to USE Installing jig saw bladeSwitch lever Paddle wifed Fig. ’ Bevel cutting Finishing edgesUsing guide rule Rip fence Using circular guideMetal cutting Maintenance Replacing carbon brushesAccessories JIG SAW $s0ED Makita Limitedone Year Warranty