Stanley Black & Decker DS06 user manual Replacing the Chain Breaker Punch, Spinning Rivets

MAINTENAN & ADJUSTMENTS

REPLACING THE CHAIN BREAKER PUNCH

If the chain breaker punch (P/N 22801) becomes worn or damaged, use the following procedures for replace- ment.

1.Remove the punch by loosening the set screw (Figure 16).

Figure 16. Removing the Punch

2.Insert a new punch into the holder and push it up until it is fully seated (Figure 17). Secure the punch to the chain breaker holder by fully tightening the set screw.

Figure 17. Replacing the Punch

SPINNING RIVETS

The following procedures explain how to spin rivets us- ing Stanley’s bench-mounted rivet spinner (P/N 20857) to assembly the chain.

1.Mount the rivet spinner flush with the side or front of a flat, clean work surface (Figure 18).

16 ► DS06 User Manual

Figure 18. Rivet Spinner Mounting

2.Lay the chain across the plastic chain supports and then rotate the supports so the rivet head is cen- tered between the take-up handle pocket and the spinner anvil (Figure 19).

Figure 19. Positioning the Chain

3.Turn the take-up handle until the chain is tight against the spinner anvil (Figure 20).

Rivet Spinner	Take-up
	Handle
Crank

Figure 20. Securing the Chain

4.Turn the rivet spinner crank a few times to center the rivet hub in the spinner anvil (Figure 21).

Take-up

Rivet SpinnerHandle Crank

Figure 21. Centering the Rivet Hub