|
| ACCESSORIES |
| |||
|
|
|
|
|
|
|
DRIVE ROLL KITS
Refer to Table C.1 for various drive roll kits that are available for the PM 255. All items in Bold are sup- plied standard with the POWER MIG.
Wire | Size | Drive Roll Kit | |
|
|
| |
Solid | |||
.035” (0.9 mm) | |||
Steel | |||
.045” (1.2 mm) | |||
| |||
|
|
| |
Cored | .035” (0.9 mm) | ||
.045” (1.2 mm) | |||
| |||
|
|
| |
Aluminum | 3/64” (1.2 mm) | ||
|
|
| |
| TABLE C.1 |
|
3/64" (1.2 mm) ALUMINUM FEEDING KIT (K1703-1)
This kit helps push feeding aluminum through stan- dard machine feeder and gun. It provides gun and wire drive conversion parts to weld with 3/64" (1.2
mm)aluminum wire. 5356 alloy aluminum wire is rec- ommended for best push feeding performance.
Kit includes drive rolls and wire guide plate for the wire drive, liner and two contact tips for the gun, along with installation instructions.
K363P READI-REEL ADAPTER
The K363P
DUAL CYLINDER MOUNTING KIT (K1702-1)
Permits stable
ALTERNATIVE MAGNUM GMAW GUN AND CABLE ASSEMBLIES
The following Magnum 250L gun and cable assem- blies are separately available for use with the PM 255. Each is rated 200 amps 60% duty cycle (or 250 amps 40% duty) and is equipped with the integrated con- nector,
|
| English Wire | Metric Wire |
Length | Part No. | Size | Size |
10' (3.0 m) |
|
| |
12' (3.6 m) | .035 | 0.9 – 1.2 mm | |
15' (4.5 m) |
|
| |
10' *3.0 m) |
|
| |
12' (3.6 m) | .025 | 0.6 – 0.8 mm | |
15' (4.5 m) |
|
| |
|
|
|
|
MAGNUM GUN CONNECTION KIT (Optional K466-6)
Using the optional
TIMER KIT INSTALLATION
(Optional K1701-1)
The timer kit adds selectable
WARNING
Remove all input power to the PM 255 before pro- ceeding.
1.Verify that the following items have been included in the kit:
A.Timer board/with harness and panel assembly .
B.Two screws.
2.Prepare for kit installation by turning the power switch off and disconnecting power from the machine.
3.Remove the lower cover panel from the front of the machine by removing the two screws which secure it using a screwdriver.
PM 255