INSTALLATION |
SAFETY PRECAUTIONS
Read this entire installation section before you start installation.
WARNING
Do not attempt to use this equipment until you have thoroughly read all operating and mainte- nance manuals supplied with your machine. They include important safety precautions, detailed engine starting, operating and maintenance instructions, and parts lists.
Hazards of Electric Shock, Engine Exhaust & Moving Parts
WARNING
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts or electrode with skin or wet cloth- ing.
• Insulate yourself from work and ground.
• Always wear dry insulating gloves.
ENGINE EXHAUST can kill.
• Use in open, well ventilated areas or vent exhaust outside.
• Do not stack anything on or near the engine.
MOVING PARTS can injure.
•Do not operate with doors open or guards off.
• Stop engine before servicing.
• Keep away from moving parts.
Only qualified personnel should install, use, or service this equipment.
LOCATION AND VENTILATION
Whenever you use the OUTBACK™ 185, be sure that clean cooling air can flow around the machineʼs gasoline engine and the generator. Avoid dusty, dirty areas. Also, keep the machine away from heat sources. Do not place the back end of the generator anywhere near hot engine exhaust from another machine. And of course, make sure that engine exhaust is ventilated to an open, outside area.
The OUTBACK™ 185 must be used outdoors. Do not set the machine in puddles or otherwise submerge it in water. Such practices pose safety hazards and cause improper operation and corrosion of parts.
Always operate the OUTBACK™ 185 with the case roof on and all machine components completely assembled. This will help to protect you from the dangers of moving parts, hot metal surfaces, and live electrical devices.
STORING
1.Store the machine in a cool, dry place when it is not in use. Protect it from dust and dirt. Keep it where it can not be accidentally damaged from construction activi- ties, moving vehicles and other hazards.
2.If you will be storing the machine for over 30 days, you should drain the fuel to protect fuel system and carbure- tor parts from gum deposits. Empty all fuel from the tank and run the engine until it stops from lack of fuel.
3.You can store the machine for up to 24 months if you use a stabilizing Additive in the fuel system. Mix the additive with the fuel in the tank and run the engine for a short time to circulate the additive through the carbu- retor.
4.While the engine is still warm, drain the oil and refill with fresh 10W30 oil.
5.Remove the spark plug and pour approximately 1/2 ounce (15ml) of engine oil into the cylinder. Replace the spark plug and crank the engine slowly to distribute the oil.
6.Clean any dirt and debris from the cylinder and cylinder head fins and housing, rotating screen, and muffler areas.
7.Store in a clean, dry area.
OUTBACK™ 185
®