CAUTION :
Always hold the tool with the base flush with the workpiece. Failure to do so may cause
aslanted cutting surface and blade breakage.
*Advance the tool very slowly when cutting curves or scrolling. Forcing the tool may cause a slanted cutting surface and blade breakage.
Bevel cutting
CAUTION :
Always unplug the tool before making any adjustments.
With the base tilted, you can make bevel cuts a t any angle between 0" and 45' (left or right). Loosen the bolt on the bottom of the tool. Move the base so that the bolt is positioned in the center of the
Crossshaped slot
Tilt the base until the desired bevel angle is obtained. The edge of the motor housing indicates the bevel angle by graduations. Then tighten the bolt to secure the base.
Edge of motor housing / | / | Base |
Graduations |
|
|
Flush cutting
Loosen the bolt on the bottom of the tool and slide the base all the way back. Then tighten the bolt to secure the base.
For 4304
10