Makita 4304 instruction manual Cutouts

Page 11

cutouts

Cutouts can be made with either of two methods A or B.

A)Boring a starting hole:

For internal cutouts without a lead-in cut from an edge, predrill starting hole more than 12 mm (15/32") in diameter. Insert the blade into this hole and hold the tool firmly against the workpiece to start your cut.

For 4304

/

Starting hole/A pStarting hole

B)Plung cutting

You need not bore a starting hole or make a lead-in cut if you carefully do as follows:

1.Tilt the tool up on the front edge of the base, with the blade point positioned just above the workpiece surface.

2.Apply firm pressure to the tool so that the front edge of the base will not move when you switch on the tool and gently lower the back end of the tool slowly.

3.As the blade slices into the workpiece, slowly lower the base of the tool down onto the workpiece surface.

4.Complete the cut in the normal manner.

 

~

For 4304

For 4305

11

Image 11
Contents Variable Speed Jig SawGeneral Safety Rules Page Additional Safety Rules Min Installingor removingthe saw blade Bottom of the inner slit Bolt ILocklever Cutting operation Speed adjusting dialFlush cutting Bevel cuttingCutouts Anti-splinteringdevice Finishing edgesMetal cutting Plastic base plateVacuum head optional accessory Guide rule rip fence optional accessoryCircular guide optional accessory Maintenance Accessories Jig saw blade JIG SAW EW B e m g 6 0 8 ~ ~ JIG SAW MAKlTA LIMrrED ONE Year Warranty