Installingthe universal shank jig saw blade
CAUTION :
Always be sure that the tool is switched off the blade.
If the universal blade clamp is used, you can use blades of other makes which have a universal shank like the one shown in the figure, with a blade width of 6.35 mm
(1/4" 1.
Insert the blade into the blade holder as far as it will go. Make sure that the end of the blade shank reaches the bottom of the inner s l i t and tighten the bolt securely with the hex wrench.
Selecting the cutting action
This tool can be operated with an orbital or a straight line cutting action. To change the cutting action, just turn the lever to the desired cutting action position. Refer to the table below to help determine the appropriate cutting action.
and unplugged before installingor removing
c
bottom of the inner slit
Bolt
7