Makita 5007NH instruction manual Maintenance, Rip fence Guide rule optional accessory

Page 11

001460

1 2

3

1. Rear handle

2. Front grip

3. Base

Hold the tool firmly. The tool is provided with both a front grip and rear handle. Use both to best grasp the tool. If both hands are holding saw, they cannot be cut by the blade. Set the base on the workpiece to be cut without the blade making any contact. Then turn the tool on and wait until the blade attains full speed. Now simply move the tool forward over the workpiece surface, keeping it flat and advancing smoothly until the sawing is completed.

To get clean cuts, keep your sawing line straight and your speed of advance uniform. If the cut fails to properly follow your intended cut line, do not attempt to turn or force the tool back to the cut line. Doing so may bind the blade and lead to dangerous kickback and possible serious injury. Release switch, wait for blade to stop and then withdraw tool. Realign tool on new cut line, and start cut again. Attempt to avoid positioning which exposes operator to chips and wood dust being ejected from saw. Use eye protection to help avoid injury.

001480

Rip fence (Guide rule) - optional accessory

1

The handy rip fence allows you to do extra-accurate straight cuts. Simply slide the rip fence up snugly against the side of the workpiece and secure it in position with the screw on the front of the base. It also makes repeated cuts of uniform width possible.

1. Rip fence (Guide rule)

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.

1

1.Adjusting screw

2.Base

001962

2

Adjusting for accuracy of 90° cut (vertical cut)

This adjustment has been made at the factory. But if it is off, adjust the adjusting screw with a hex wrench while squaring the blade with the base using a triangular rule, try square, etc.

11

Image 11
Contents Circular Saw Specifications Personal Safety Specific Safety Rules Page Ward while the blade is in motion or Kick Page Symbols Sighting Adjusting depth of cutFunctional Description Bevel cuttingOperation AssemblySwitch action Removing or installing saw bladeAdjusting for accuracy of 90 cut vertical cut MaintenanceRip fence Guide rule optional accessory Replacing carbon brushes AccessoriesMakita U.S.A., Inc Mail this Portion Factory Service Centers Makita Limited ONE Year Warranty