001505
1 
1. Triangular rule
001145 |
1 |
1. Limit mark
001515
|
|
|
|
1 |
| 2 | |
| |||
1.Brush holder cap
2.Screwdriver
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only iden- tical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
•These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
•Steel &
| Combination | General purpose blade for fast and smooth rip, |
|
| crosscuts and miters. |
|
|
|
| Pressure treated/ | Designed for fast cutting of pressure treated |
| Wet lumber | and wet lumber. |
|
|
|
| Fine cross cuts | For |
|
|
|
| • Rip fence (Guide rule) | |
12 | • Wrench 13 |
|