Makita 5007MG-R dimensions Bow stop ring E-12 viewed from a

P 4/10

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-2. Base Complete (cont.)

DISASSEMBLING

4) Unscrew two M5x8 Hex socket set screws that secure 6-7 Shoulder pins. (Fig. 8)

Note: Do not unscrew the M5x8 Hex socket set screw used for fine adjustment of the angle of Base to Saw blade in this step.

5) Remove two 6-7 Shoulder pins. Base complete can now be separated from Motor section. (Fig. 9)

Fig. 8	Fig. 9
Depth guide	Angular guide

Base complete Motor section

Shoulder pin 6-7	Angular guide
(a)	(b)
	(c)

Base complete, viewed from bottom
		Shoulder pin 6-7	Base complete
Hex socket set screw M5x8
(a), (b): for securing Shoulder	pin 6-7
(c): for fine adjustment of the angle of Base to Saw blade

ASSEMBLING

Do the reverse of the disassembling steps.

Note: Bow stop ring E-12 is not reversible when assembled to Lever 56.

Be sure to assemble it in place as described in Fig. 10.

Fig. 10

[A]

Motor housing

Lever 56

Hex nut M8-13

Bow stop ring E-12

Bow stop ring E-12 viewed from [A]

The concave side of Bow stop ring E-12 must be positioned on Motor housing side.

(Motor housing side)

concave side

Hex nut M8-13 Lever 56

Bow stop ring E-12