OPTIONAL ACCESSORIES
K964-1 Undercarriage with Pivoting Single Gas Cylinder Platform - This undercarriage features a piv- oting platform to easily load and unload the gas cylin- der without lifting. It was designed specifically for the Square Wave TIG 175 power source, and accommo- dates 7” to 9 1/4” diameter gas cylinders. The under- carriage comes completely assembled and mounts directly to the power source.
K812 Hand Amptroltm - A Lincoln Foot Amptrol is included with the Square Wave TIG 175 for remote cur- rent control while TIG welding. The K812 Hand Amptrol may be used in place of the Foot Amptrol if a thumb operated remote control is desired.
K814 Arc Start Switch - The Arc Start Switch may be used instead of the Foot Amptrol included with the Square Wave TIG 175. It allows on/off TIG welding at the current set by the Current Control on the control panel. The Arc Start Switch does not provide remote current control.
Magnum® LA-9 and LA-17 TIG Torches - The fol- lowing standard Magnum® TIG torches with one-piece cable may be used with the Square Wave TIG 175.
• K859-1 | LA-9 | 12.5 ft | medium back cap |
• K859-5 | LA-9 | 25 ft | medium back cap |
• K860-1 | LA-17 | 12.5 ft | long back cap |
• K860-5 | LA-17 | 25 ft | long back cap |
NOTE: Each torch requires a quick connector plug (S22529-1) and strain relief boot (M17255) be installed onto the cable. Collets, collet bodies, and nozzles are not included and must be ordered separately.
Quick Connect Plug (S22529-1) and Strain Relief Boot (M17255) - One of each is shipped with the welder to connect the Magnum LA-9 torch. If you do not care to interchange these parts between torches (one of each is required to connect Magnum LA-9 or LA-17 TIG torches with one-piece cable to the Square Wave TIG 175) you may order additional sets. The quick connect plug provides connection for both gas and welding current.
Tungstens, Collets, Collet Holders, Gas Cups, Backcaps and Other Torch Parts - A Lincoln Magnum LA-9 with 12.5 ft. one-piece cable is included with the Square Wave TIG 175. Standard Magnum® parts and accessories for this torch may be used.
TIG Torch Parts Kits - Parts kits are available for the LA-9 and LA-17 TIG torches. These kits include back cap, collets, collet bodies, nozzles and tungstens.
Order KP507 for LA-9 torches Order KP508 for LA-17 torches
See publication E12.150 for parts kits breakdown.
Cut Length Consumables - TIG welding filler metals are available for welding stainless steel, mild steel, alu- minum and copper alloys. See publication C9.10.
