Lincoln Electric IM10055 specifications Helmet Information

Page 4

HELMET INFORMATION

This Auto-Darkening Welding Helmet will automatically change from a light state (shade 3.5) to a dark state (Shade 9-13) when arc welding starts.

The filter automatically returns to a light state when the arc stops. Shade control adjustments can be made while welding.

Match your welding application to the shade indicated on the shade chart. (See Page 6)

• Operating temperature: 14°F ~ 131°F

(-10°C ~ 55°C).

Do not use or open the auto-darkening filter if damaged by shock, vibra- tion or pressure.

Keep the sensors and solar cell clean. Clean the filter cartridge using a soapy water solution and soft cloth which should be damp but not saturat- ed.

This Auto-Darkening Welding Helmet is designed for use with GMAW, GTAW, MMAW welding, or Plasma Arc and air carbon arc cutting.

The cartridge provides protection from harmful UV and IR radiation, in both dark and light states.

The cartridge contains two sensors to detect the light from the welding arc, resulting in the lens darkening to a selected welding shade.

Do not use solvents or abrasive cleaning detergent.

If cover lens is spattered or covered with dirt, it should be replaced imme- diately.

Use only replacement parts specified in this manual.

Do not use the helmet without inside and outside cover lenses properly installed.

2

Image 4
Contents AUTO-DARKENING Helmet Table of Contents ARC Rays can injure eyes and burn skin Safety Warnings Read Before UsingFumes and Gases can be dangerous to your health Helmet Information Specifications DINHeadgear Adjustment Operating InstructionsCartridge OPERATION/FEATURES Delay Time ControlSolar Power Variable Shade ControlShade Guide Settings Guide for Shade NumbersHelmet Care and Maintenance Change the Shade Cartridge See figureTrouble Shooting Guide Problem Possible Cause SolutionWarranty Information Spatter Damage is not Covered by WarrantyReplacement Parts Description QTY