Milwaukee 6223 Operation, Starting, Stopping, and Controlling Speed Cat. No, Typical Application

Page 6

OPERATION

WARNING!

To reduce the risk of injury, wear safety goggles or glasses with side shields. Unplug the tool before changing accessories or making adjustments.

Two Speed Switch (Cat. Nos. 6223, 6225, 6236)

MILWAUKEE Two-Speed Band Saws are equipped with a speed change switch located below the trigger on the handle. To change speeds, stop the motor and slide the speed change switch to "HI" or "LO" as indicated on the tool. For cutting problem materials, use "LO" speed. Never change from one speed to the other while the motor is running.

Starting, Stopping, and Controlling Speed (Cat. No. 6230)

1.To start the tool, grasp the handle firmly and pull the trigger.

2.To vary the speed, increase or decrease pressure on the trigger. The further the trigger is pulled, the greater the speed.

3.To select a maximum preset speed at any point within the speed range, rotate the red knurled knob located on the trigger to the desired position.

4.To stop the tool, release the trigger. Allow the tool to come to a complete stop before removing the blade from a partial cut or laying the tool down.

Typical Application (Fig. 2 & 3)

1.Keep the blade off the workpiece until the motor has reached the selected speed.

2.Start cutting on a surface where the greatest number of teeth will be in contact with the workpiece at one time (Fig 2).

Fig. 2

CorrectIncorrect

3.Place the work steady rest against the workpiece and lower the moving saw blade into the cut.

4.Do not bear down while cutting. The weight of the tool will supply adequate pressure for the fastest cutting.

5.When completing a cut, hold the tool firmly so it will not fall against the workpiece (Fig. 3).

Fig. 3

page 6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Operators Manual Personal Safety General Safety Rules Read and Understand ALL InstructionsElectrical Safety Tool USE and Care ServiceSpecific Safety Rules Functional DescriptionGrounding Guidelines for Using Extension CordsRecommended Minimum Wire Gauge For Extension Cords Extension CordsTool Assembly Changing BladesOperation Starting, Stopping, and Controlling Speed Cat. NoTypical Application Warranty MaintenanceAccessories CleaningUtilisation ET Entretien DES Outils Conservez CES Instructions Aire DE TravailSécurité Électrique Sécurité DES Personnes RéparationRègles DE Sécurité Particulière Description FonctionnelleCordons DE Rallonge Calibres minimaux recommandés pour Les cordons de rallongeMise À LA Terre Avertissement Trois dentsMontage DE Loutil Avertissement Changement Des LamesManiement Avertissement Démarrage, arrêt et maîtrise de l’outil No de catApplication typique et Garantie Maintenance AvertissementAccessoires Avertissement NettoyageUSO Y Mantenimiento DE LA Herramienta Guarde Estas Instrucciones Area DE TrabajoSeguridad Electrica Seguridad PersonalCat Capacidad Cinta Reglas Especificas DE SeguridadDescripcion Funcional Barra RecomendTierra ¡ADVERTENCIA Extensiónes EléctricasGuías para el uso de cables de extensión Ensambaje DE LA Herramienta ¡ADVERTENCIA Cambio de la cintaOperacion ¡ADVERTENCIA Arranque, paro y control de la velocidad Cat. NoAplicaciones típicas y Garantia Mantenimiento ¡ADVERTENCIAAccesorios ¡ADVERTENCIA LimpiezaUnited States
Top Page Image Contents