Wilton 4103, 4126AC, 4106 manual Introduction, Setup and Operation, Installation of Work Rest

Page 7

Introduction

This manual includes operating and maintenance instructions for the Wilton Model 4103, 4106 and 4126AC Square Wheel Belt Grinder. The manual also includes parts listings and illustrations of replaceable parts.

Refer to Figures 1 and 2 for key features of the Square Wheel Belt Grinder.

Setup and Operation

The Square Wheel Belt Grinder can be mounted on a work bench or an optional pedestal. The grinder should be secured to the work bench or pedestal using the four holes in the base of the grinder. (Refer to Assembly of Pedestal for machines that are to be pedestal-mounted.)

Installation of Work Rest

The work rest mounts on the left side of the head casting. Attach the work rest using the socket head cap screw provided with the machine.

The slot in the work rest has a lip against which the cap screw is tightened. Place the hole at the end of the slot over the cap screw. Then slide the rest inward until the work rest is in position in front of the contact wheel. Tighten the cap screw.

Belt Tension Lever	Belt Tracking	Inverter	Belt Tracking
	Adjustment		Adjustment
Motor	Upper		Upper
Motor	Guard		Upper
		ON/OFF	Guard
		ON/OFF
		Switch
		Motor	7
Switch	Work		7
Switch	Rest		Work
	Contact		Work
	Contact		Rest
	Wheel		Contact
			Contact
			Wheel
	Pedestal		Pedestal
			Pedestal

Figure 1: Square Wheel Grinder Features	Figure 2: Square Wheel Grinder Features
(single speed)	(variable speed)

Image 7

Contents Square Wheel Belt Grinder Page Table of Contents Specifications Model Model 4126AC General SpecificationsYou the stationary power tool user- hold the key to safety Machinery general safety warningsWhen setting up machine When using machineWire sizes Safety requirements for abrasive grinding machinesGeneral Electrical Cautions Installation of Work Rest Setup and OperationIntroduction Electrical Connection Vacuum ConnectionOperating Controls Typical Uses for the Square Wheel Belt Grinder Optional FeaturesInstallation of Platen MaintenanceCleaning Replacement of Contact WheelReplacement of Inverter Replacement of Grinding BeltChecking Belt Tracking Wiring Diagrams Replacement Parts TroubleshootingProblem Probable Cause Suggested Remedy Exploded View Square Wheel Belt Grinder Parts List Square Wheel Belt Grinder Parts List Inverter Belt Grinder Pedestal AccessoriesDust Collection Systems Vacuum Scoop Exploded View Exploded View Vacuum ScoopAir Cushioned Dead Head Assembly Parts Breakdown Air Cushioned Dead Head AssemblyHub and Wheel Assembly Unpacking Assembly of PedestalAssembly Mounting ProcedureAssembly of Grinding Machine and Pedestal Operation InstallationMaintenance Dust Collection System OptionalDisassembly Exploded View Model 5511885 Dust Collection System Wiring Information Dust Collection System Parts List Model 5511885 Dust Collection SystemPage WMH Tool Group