Wilton 4106, 4126AC, 4103 manual Vacuum Connection, Electrical Connection, Operating Controls

Page 8

Vacuum Connection

NOTE: A variety of vacuum system options are available. (Refer to Accessories section.)

The grinder uses a front mounted vacuum system. Refer to Fgure 3. Install the vacuum system components as follows:

1.Slide the support bracket into the channel secured to belt grinder base. Install one knob in the belt grinder base to secure the support bracket.

NOTE: Refer to vacuum scoop exploded view, Figure 11 when installing channel.

2.Slide the ducted scoop onto the support bracket. Install remaining knob in the support bracket to secure the scoop.

3.Connect hose to exhaust duct and secure with a clamp.

8

Clamping

Knob

Support

Bracket

Scoop

Clamping

Knob

Figure 3: Vacuum Connection

Electrical Connection

Refer to the Wiring Diagram section for wiring information. Connection to electrical power should be made by a qualified electrician. Observe local electrical codes when connecting the machine.

Operating Controls

Model 4103/4106

The ON/OFF switch for the Model 4103/4106 grinder is located in a switch box mounted on the drive motor.

Model 4126AC

NOTE: Refer to Figure 4. Use only the inverter controls defined in the following procedures. The inverter is pre-programmed at the factory and requires no further programming.The controls for the Model 4126AC grinder are located on the inverter. The ON/OFF switch is located on the left side of the inverter. Start the grinder by setting the ON/OFF switch to ON.

Press the FWD RUN pushbutton on the inverter and set the speed using the up/down arrow keys (to the right of the speed display). Press the up arrow to increase speed; press the down arrow to reduce speed. The display on the inverter shows drive motor speed in revolutions per minute. Press the STOP button on the inverter to stop the grinder. Then set the ON/OFF switch to OFF.

 

STOP

 

Button

FWD (For-

Up

Down

ward) Button

 

On/Off

 

Switch

 

Speed Display

 

(RPM)

 

Figure 4: Operating Controls

(Model 4126AC)

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Square Wheel Belt Grinder Page Table of Contents General Specifications Specifications Model Model 4126ACMachinery general safety warnings When setting up machineWhen using machine You the stationary power tool user- hold the key to safetyGeneral Electrical Cautions Safety requirements for abrasive grinding machinesWire sizes Introduction Setup and OperationInstallation of Work Rest Operating Controls Vacuum ConnectionElectrical Connection Optional Features Typical Uses for the Square Wheel Belt GrinderMaintenance CleaningReplacement of Contact Wheel Installation of PlatenChecking Belt Tracking Replacement of Grinding BeltReplacement of Inverter Wiring Diagrams Problem Probable Cause Suggested Remedy TroubleshootingReplacement Parts Exploded View Square Wheel Belt Grinder Parts List Square Wheel Belt Grinder Parts List Inverter Dust Collection Systems AccessoriesBelt Grinder Pedestal Exploded View Vacuum Scoop Vacuum Scoop Exploded ViewAir Cushioned Dead Head Assembly Air Cushioned Dead Head Assembly Parts BreakdownHub and Wheel Assembly Assembly of Pedestal AssemblyMounting Procedure UnpackingAssembly of Grinding Machine and Pedestal Installation MaintenanceDust Collection System Optional OperationDisassembly Exploded View Model 5511885 Dust Collection System Parts List Model 5511885 Dust Collection System Wiring Information Dust Collection SystemPage WMH Tool Group
Top Page Image Contents