Wilton 4106, 4126AC, 4103 Dust Collection System Optional, Installation, Operation, Maintenance

Page 23

Dust Collection System (Optional)

Installation

Transport the shipping container to the installation site. Unpack the dust collection system and check for damage. Contact the carrier if damage is found.

Open the installation kit (refer to Optional Accessories in the parts listing for installation kits). Install cover and debris collection drawer if removed. Slip a hose clamp over the 3-inch vacuum hose. Slip the hose on the inlet duct(s). Move the clamp over the duct to secure the hose.

Repeat the procedure to connect the hose to the other duct on the grinding machine.

Filter

Check for accumulation of debris. Replace the filter at intervals that you determine are appropriate for your shop environment and machine utilization.

Drawer Seal

Check the drawer seal periodically and replace if damaged or missing. Keep the seal in good condition to help maintain collection system efficiency.

Electrical Connection

Refer to the Dust Collection System Wiring Diagram for wiring information. Connection to electrical power should be made by a qualified electrician. Observe local electrical codes when connecting the machine.

Operation

The dust collection system motor is started by setting the toggle switch on the motor to the ON position. Set the switch to OFF to shut down the dust collection system.

Maintenance

WARNING:

ON/OFF switch on motor at rear of dust collection system

Removable cover – remove for interior cleaning/access to impeller

Second Inlet Duct on this side

23

·MAKE SURE YOU DISCONNECT ELECTRICAL POWER TO THE DUST COLLECTION SYSTEM BEFORE PERFORMING MAINTENANCE.

FAILURE TO DO SO MAY RESULT INJURY TO THE OPERATOR AND/OR MAINTENANCE PERSONNEL.

·DO NOT OPERATE THE DUST COLLECTION SYSTEM WITH THE COVER REMOVED. INJURY TO FINGERS AND HANDS FROM THE FAN BLADES, AND INGESTION OF LOOSE FITTING CLOTHING INTO THE AIR INLET WITH RESULT- ANT INJURY IS ALSO POSSIBLE.

Outlet filter at rear removes fine debris from outlet air stream

Inlet Duct – Connect 3 inch hose - secure with clamp

Chip Drawer - Pull to Open

Cleaning

Figure 17: Dust Collector Assembled View

 

Periodically dispose of accumulated chips and debris

 

from the chip drawer. Use a brush to loosen debris

 

from internal surfaces. Use a vacuum cleaner to clean

 

up the loosened debris.

 

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Square Wheel Belt Grinder Page Table of Contents Specifications Model Model 4126AC General SpecificationsYou the stationary power tool user- hold the key to safety Machinery general safety warningsWhen setting up machine When using machineGeneral Electrical Cautions Safety requirements for abrasive grinding machinesWire sizes Introduction Setup and OperationInstallation of Work Rest Operating Controls Vacuum ConnectionElectrical Connection Typical Uses for the Square Wheel Belt Grinder Optional FeaturesInstallation of Platen MaintenanceCleaning Replacement of Contact WheelChecking Belt Tracking Replacement of Grinding BeltReplacement of Inverter Wiring Diagrams Problem Probable Cause Suggested Remedy TroubleshootingReplacement Parts Exploded View Square Wheel Belt Grinder Parts List Square Wheel Belt Grinder Parts List Inverter Dust Collection Systems AccessoriesBelt Grinder Pedestal Vacuum Scoop Exploded View Exploded View Vacuum ScoopAir Cushioned Dead Head Assembly Parts Breakdown Air Cushioned Dead Head Assembly Hub and Wheel Assembly Unpacking Assembly of PedestalAssembly Mounting ProcedureAssembly of Grinding Machine and Pedestal Operation InstallationMaintenance Dust Collection System OptionalDisassembly Exploded View Model 5511885 Dust Collection System Wiring Information Dust Collection System Parts List Model 5511885 Dust Collection SystemPage WMH Tool Group
Top Page Image Contents