HP E1Y97UT 11.6' E1Y97UT#ABA manual Installing and Removing Drives

Installing and Removing Drives

When installing additional drives, follow these guidelines:

●The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA connector on the system board.

●Connect a SATA optical drive to the white SATA connector on the system board..

●Connect a media card reader USB cable to the USB connector on the system board.

●The system does not support Parallel ATA (PATA) optical drives or PATA hard drives.

CAUTION: To prevent loss of work and damage to the computer or drive:

If you are inserting or removing a drive, shut down the operating system properly, turn off the computer, and unplug the power cord. Do not remove a drive while the computer is on or in standby mode.

Before handling a drive, ensure that you are discharged of static electricity. While handling a drive, avoid touching the connector.

Handle a drive carefully; do not drop it.

Do not use excessive force when inserting a drive.

Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields such as monitors or speakers.

If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label the package “Fragile: Handle With Care.”

110 Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis