8.To install a new expansion card, hold the card just above the expansion socket on the system board then move the card toward the rear of the chassis so that the bottom of the bracket on the card slides into the small slot on the chassis. Press the card straight down into the expansion socket on the system board.

Figure 6-14Installing an Expansion Card

NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot.

9.Replace the slot cover lock and secure it in place with the screw that was previously removed. Figure 6-15Securing the Expansion Cards and Slot Covers

10.Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed.

11.Replace the computer access panel.

102

Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis

Page 111 Page 113
Page 112
Image 112
HP E1Y97UT 11.6' E1Y97UT#ABA manual
Page 111 Page 113
Top Page Image Contents