HP E1Y97UT 11.6' E1Y97UT#ABA manual Cable Management

12.Reconnect the power cord and any external devices, then turn on the computer.

13.Lock any security devices that were disengaged when the access panel was removed.

14.Reconfigure the computer, if necessary. Refer to Computer Setup (F10) Utility on page 4 for instructions on using Computer Setup.

Cable Management

Always follow good cable management practices when working inside the computer.

●Keep cables away from major heat sources like the heat sink.

●Do not jam cables on top of expansion cards or memory modules. Printed circuit cards like these are not designed to take excessive pressure on them.

●Some flat ribbon cables come prefolded. Never change the folds on these cables.

●Never bend a SATA data cable tighter than a 30 mm (1.18 in) radius.

●Never crease a SATA data cable.

●Do not rely on components like the drive cage, power supply, or computer cover to push cables down into the chassis. Always position the cables to lay properly by themselves.

When removing the power supply power cable from the 24-pin connector on the system board, always follow these steps:

1.Squeeze on the top of the retaining latch attached to the cable end of the connector (1).

2.Grasp the cable end of the connector and pull it straight up (2).

CAUTION: Always pull the connector - NEVER pull on the cable. Pulling on the cable could damage the cable and result in a failed power supply.

60 Chapter 5 Removal and Replacement Procedures Minitower (MT) Chassis