HP E1Y97UT 11.6' E1Y97UT#ABA Bezel Blanks, DDR3-SDRAM DIMMs, Model Number Maximum Memory

Bezel Blanks

On some models, there are bezel blanks covering the 3.5-inch and 5.25-inch external drive bays that need to be removed before installing a drive. To remove a bezel blank:

1.Remove the front bezel (Front Bezel on page 44).

2.To remove the lower 5.25-inch bezel blank, gently twist and pull on the bezel blank until it breaks free from the front bezel (1), then discard the bezel blank. If the blank needs to be replaced at a later date, you can order a replacement blank from HP.

3.To remove the 3.5-inch bezel blank, press the two retaining tabs towards the outer left edge of the bezel (2) and pull the bezel blank inwards to free it from the front bezel (3).

Figure 5-3Removing a Bezel Blank

4.Replace the front bezel.

Memory

The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3- SDRAM) dual inline memory modules (DIMMs).

DDR3-SDRAM DIMMs

The memory sockets on the system board can be populated with up to four industry-standard DIMMs. These memory sockets are populated with at least one preinstalled DIMM. To achieve the maximum memory support, you can populate the system board with up to either 8 GB or 16 GB of memory configured in a high-performing dual channel mode, depending on model.

Model Number	Maximum Memory
HP Pro 3120	8 GB
HP Pro 3125	16 GB
HP Pro 3130	16 GB

Bezel Blanks 45