Weider Official Manual for Assembly Instructions and Guide for Home Gym Equipment

ASSEMBLY

Before beginning assembly, carefully read the following information and instructions:

¥Place all parts of the WEIDER 8530 in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.

¥The assembly is broken into five stages: 1) frame assembly, 2) press and butterfly arm assembly,

3) cable and pulley assembly, 4) seat and back- rest assembly, and 5) VKR assembly. The hard- ware for each stage is packaged separately.

¥Wait until you begin each assembly stage to open the parts bag labeled for that assembly stage.

¥For help identifying the small parts used in assembly, use the PART IDENTIFICATION

CHART located in the center of this manual.

Note: Some small parts may have been pre- attached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached.

¥As you assemble the WEIDER 8530, be sure that all parts are oriented as shown in the drawings.

¥Tighten all parts as you assemble them, unless instructed to do otherwise.

THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY:

¥Two (2) adjustable wrenches

¥One (1) standard screwdriver

¥One (1) phillips screwdriver

¥One (1) rubber mallet

¥Lubricant, such as grease or petroleum jelly, and soapy water will also be needed.

Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches.

FRAME ASSEMBLY

1.Before beginning assembly, be sure that you have read and understand the infor- mation in the box above.

Press a 2Ó Inner Cap (27) into the indicated end of the Stabilizer (5). Press 2Ó Outer Caps (51) onto the other two locations on the Stabilizer. Press a 2Ó Inner Cap into the end of the Base (4).

Insert four 5/16Ó x 2 1/2Ó Carriage Bolts (1) up through the Stabilizer (5).

Attach the Base (4) to the Stabilizer (5) with two 5/16Ó x 2 3/4Ó Bolts (11), two 5/16Ó Flat Washers (8), and two 5/16Ó Nylon Locknuts

(3). Do not tighten the Nylon Locknuts yet.

Slide the VKR Upright (74) and the Squat Arm Upright (56) onto the 5/16Ó x 2 1/2Ó Carriage Bolts (1) in the Stabilizer (5). The high side of the brackets on the VKR Upright and Squat Arm Upright should be on the side shown. Hand-tighten four 5/16Ó Nylon Locknuts (3) onto the Carriage Bolts.

Do not tighten the Nylon Locknuts yet.

1
	56
	High
	Side
74
	3
	27
51	11
3	8
	5
	1
	4
	27
51	1
	3

4