HP E1Y97UT 11.6' E1Y97UT#ABA manual Removing the Hard Drive

5.Disconnect the power cable (1), data cable (2), and eject cables (3) from the rear of the optical drive.

Figure 6-23Disconnecting the Optical Drive Cables

6.Slide the drive out the front of the unit. Figure 6-24Removing the Optical Drive

NOTE: To replace the drive, reverse the removal procedure.

When installing an optical drive, slide it into the drive bay until it snaps into place.

Removing the Hard Drive

NOTE: The system does not support Parallel ATA (PATA) hard drives.

Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive.

114 Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis