-Misuse of this machine can cause serious injury.
-For safety, machine must be set up, used and serviced properly.
-Read, understand and follow instructions in the Operating Instructions and Parts Manual which was shipped with your machine.
When Setting up Machine:
-Always avoid using machine in damp or poorly lighted work areas.
-Always be sure the machine support is se- curely anchored to the floor or the work bench.
When Using Machine:
-Always wear safety glasses with side shields (See ANSI Z87.1)
-Never wear loose clothing or jewelry.
-Never overreach - you may slip and fall.
When Servicing Machine:
-Always disconnect the machine from its electri- cal supply while servicing.
- Always follow instructions in Operating Instruc- tions and Parts Manual when changing acces- sory tools or parts.
-Never modify the machine without consulting Wilton Corporation.
You - the Stationary Power Tool User - Hold the Key to Safety.
Read and follow these simple rules for best results and full benefits from your machine. Used properly, Wilton’s machinery is among the best in design and safety. However, any machine used improperly can be rendered inefficient and unsafe. It is absolutely mandatory that those who use our products be properly trained in how to use them correctly. They should read and understand the Operating Instruc- tions and Parts Manual as well as all labels affixed to the machine. Failure in following all of these warn- ings can cause serious injuries.
Machinery General Safety Warnings
6
1.Always wear protective eye wear when
operating machinery. Eye wear shall be impact resistant, protective safety glasses with side shields which comply with ANSI Z87.1 specifications. Use of eye wear which does not comply with ANSI Z87.1specifications could result in severe injury from breakage of eye protection.
2.Wear proper apparel. No loose clothing or jewelry which can get caught in moving parts. Rubber soled footwear is recommended for best footing.
3.Do not overreach. Failure to maintain proper work- ing position can cause you to fall into the machine or cause your clothing to get caught pullingyou into the machine.
4.Keep guards in place and in proper working order. Do not operate the machine with guards removed.
5.Avoid dangerous working environments. Do not use stationary machine tools in wet or damp locations. Keep work areas clean and well lit.
6.Avoid accidental starts by being sure the start switch is OFF before plugging in the machine.
7.Never leave the machine running while unattended. Machine shall be shut off whenever itis not in op- eration.
8.Disconnect electrical power before servicing. Whenever changing accessories or general main- tenance is done on the machine, electrical power to the machine must be disconnected before work
is done.
9.Maintain all machine tools with care. Follow all maintenance instructions for lubricating and the changing of accessories. No attempt shall be made to modify or have makeshift repairs done to the machine. This not only voids the warranty but also renders the machine unsafe.
10.Machinery must be anchored to the floor.
11.Secure work. Use clamps or a vise to hold work, when practical. It is safer than using your hands and it frees both hands to operate the machine.
12.Never brush away chips while the machine is in operation.
13.Keep work area clean. Cluttered areas invite ac- cidents.
14.Remove adjusting keys and wrenches before turn- ing machine on.
15.Use the right tool. Don’t force a tool or attach- ment to do a job it was not designed for.
16.Use only recommended accessories and follow manufacturers instructions pertaining to them.
17.Keep hands in sight and clear of all moving parts and cutting surfaces.
18.All visitors should be kept at a safe distance from the work area. Make workshop completely safe by using padlocks, master switches, or by removing starter keys.