Makita MAC700 owner manual Specification Chart, Scfm @ 40 Psig Scfm @ 90 Psig

Page 1

OWNERS MANUAL FOR

Oil Lubricated Air Compressor

MODEL No

MAC700

SPECIFICATION CHART

Model #	MAC700
Horsepower	2
SCFM @ 40 PSIG	3.8
SCFM @ 90 PSIG	3.3
Cut-In Pressure	100 PSI
Cut-Out Pressure	130 PSI
Bore	47 mm
Stroke	44 mm
Voltage -Single Phase	120
Motor RPM	1720
Amperage @ max pressure	12.4
Tank Size	2.6 Gallon
CSA/US Listed	Yes

Minimum Circuit Requirement: 15 AMPS

*A circuit breaker is preferred. Use only a fuse or circuit breaker that is the same rating as the branch circuit the air compressor is operated on. If the air compressor is connected to a circuit protected by fuses, use time delay fuses.

IMPORTANT — Read the Safety Guidelines and ALL

instructions carefully before operating.

www.makitatools.com

Image 1

Contents Scfm @ 40 Psig Scfm @ 90 Psig Specification ChartMinimum Circuit Requirement 15 Amps Table of Contents Hazard What can Happen HOW to Prevent IT Important Safety InstructionsRisk UnsafeRisk of Air AccessoriesTank BurstingShock ElectricExplosion or FireCompressed Risk fromAir Moving PartsDuty Cycle GlossaryGeneral Information ON-RECEIPT InspectionDescription Operation StorageLocation of the AIR Compressor Installation BREAK-IN ProceduresExtension Cords Initial Start Up ProcedureAmp Length Rating Cord in Feet PipingDaily Start-up Checklist Operating ProceduresWhen you are finished Routine Maintenance Schedule MaintenanceCold Weather Conditions Filling with OilUnits with External Brass Check Valve Replacement Service InstructionsMotor Not Over Tighten Troubleshooting GuideINTO, Weld or Otherwise Modify AIR Tank or IT will WEAKEN.Problem Cause Correction Problem Cause Correction California Arizona Illinois NEW YorkColorado FloridaWarranty Policy Makita Limited ONE Year WarrantyMail this Portion Makita U.S.A., Inc

MODEL No

MAC700

SPECIFICATION CHART

SCFM @ 40 PSIG

SCFM @ 90 PSIG

Minimum Circuit Requirement: 15 AMPS