Makita C owner manual Routine Maintenance Schedule

Page 12

MAINTENANCE

WARNING: UNIT CYCLES AUTOMATICALLY WHEN POWER IS ON. WHEN DOING MAINTENANCE, YOU MAY BE EXPOSED TO VOLTAGE SOURCES, COMPRESSED AIR OR MOVING PARTS. PERSONAL INJURIES CAN OCCUR. BEFORE PERFORMING ANY MAINTENANCE OR REPAIR, UNPLUG THE COMPRESSOR AND BLEED OFF ALL AIR PRESSURE.

To ensure efficient operation and longer life of the air compressor unit, a routine maintenance schedule should be prepared and followed. The following routine maintenance schedule is geared to a unit in a normal working environment operating on a daily basis. If necessary, the schedule should be modified to suit the conditions under which your compressor is used. The modifications will depend upon the hours of operation and the working environment. Compressor units in an extremely dirty and/or hostile environment will require a greater frequency of all maintenance checks.

ROUTINE

MAINTENANCE

SCHEDULE

1.Drain water from the air tank, any moisture separators or transformers.

2.Check for any unusual noise and/or vibration.

3.Manually check all safety valves to make sure they are

operating properly.

4.Inspect air lines and fittings for leaks; correct as necessary.

Each year of operation or if a problem is suspected:

Check condition of air compressor pump intake and exhaust valves.

Check condition of check valve. Replace if damaged or worn out.

WARNING:

Do NOT use this compressor

in locations where the temperature drops to or below 32 degrees F or where the ambient temperature exceeds 104 degrees F.

Page 12

Image 12
Contents Scfm @ 40 Psig Scfm @ 90 Psig Minimum Circuit Requirement 15 AmpsTable of Contents Risk UnsafeOperation Accessories Risk of AirTank BurstingElectric ShockExplosion or FireRisk from CompressedAir Moving PartsGlossary Duty CycleGeneral Information ON-RECEIPT InspectionStorage Description OperationMotor Thermal Overload Installation BREAK-IN Procedures Location of the AIR CompressorInitial Start Up Procedure Extension CordsAmp Length Rating Cord in Feet 150Operating Procedures Daily Start-up ChecklistWhen you are finished Maintenance Routine Maintenance ScheduleService Instructions Units with External Brass Check Valve ReplacementMotor Troubleshooting Guide Not Over TightenINTO, Weld or Otherwise Modify AIR Tank or IT will WEAKEN.Problem Cause Correction Problem Cause Correction Compressor Maintenance LOG Page Makita Warranty Warranty Policy