Makita owner manual Scfm @ 40 Psig Scfm @ 90 Psig, Minimum Circuit Requirement 15 Amps

Page 1

OWNERS MANUAL FOR

Oil Free Air Compressor

MODEL No

$C

SPECIFICATION CHART

Model #	AC001
Horsepower	1/6 HP
SCFM @ 40 PSIG	0.58
SCFM @ 90 PSIG	0.45
Cut-In Pressure	95 PSI
Cut-Out Pressure	125 PSI
Bore	32 mm
Stroke	11 mm
Voltage -Single Phase	120
Motor RPM	3400
Amperage @ max pressure	1.8
Tank Size	1 Gallon
CSA/US Listed	Yes

Minimum Circuit Requirement: 15 AMPS

*A circuit breaker is preferred. Use only a fuse or circuit breaker that is the same rating as the branch circuit the air compressor is operated on. If the air compressor is connected to a circuit protected by fuses, use time delay fuses.

IMPORTANT — Read the Safety Guidelines and ALL

instructions carefully before operating.

www.makita.com

Image 1

Contents Minimum Circuit Requirement 15 Amps Scfm @ 40 Psig Scfm @ 90 PsigTable of Contents Unsafe RiskOperation Risk of Air AccessoriesTank BurstingShock ElectricExplosion or FireCompressed Risk fromAir Moving PartsDuty Cycle GlossaryGeneral Information ON-RECEIPT InspectionDescription Operation StorageMotor Thermal Overload Location of the AIR Compressor Installation BREAK-IN ProceduresExtension Cords Initial Start Up ProcedureAmp Length Rating Cord in Feet 150Daily Start-up Checklist Operating ProceduresWhen you are finished Routine Maintenance Schedule MaintenanceUnits with External Brass Check Valve Replacement Service InstructionsMotor Not Over Tighten Troubleshooting GuideINTO, Weld or Otherwise Modify AIR Tank or IT will WEAKEN.Problem Cause Correction Problem Cause Correction Compressor Maintenance LOG Page Warranty Policy Makita Warranty