Specifications
Electrical Requirements | 120 V~ / 60 Hz | |
|
| |
Output Voltage | 12 VDC / 1.5 Amps | |
|
| |
Charging Method | ||
|
| |
Status Indicators | Red, Yellow and | |
Green LED lights | ||
| ||
| On / Off trickle | |
Overload Protection | charging with Thermal | |
| Overload Protection | |
Additional Protection | Short Circuit and | |
Polarity Protection | ||
|
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Instructions for putting into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Unplug the tool from its electrical outlet and disconnect from battery before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Mounting
1.The Battery Charger must be mount- ed near the battery in the engine compartment of the vehicle.
2.Leave at least
3.You can mount the Charger on the vehicle engine compartment wall near the battery, or you can mount it on a bracket held in place by the bat- tery.
Bracket B (6)
Bracket A (9)
Side View with Brackets
Front View with Brackets
4.For Engine Compartment Wall mounting, mark and predrill wall us- ing Bracket A (9) or Bracket B (6) as a template. See Figure 1 above. Be
SKU 99857 | For technical questions, please call | Page 8 |