Black & Decker VEC012C, 90550870 instruction manual Read ALL Instructions

Page 2

90550870 VEC012C EN SP.qxp:VEC012C_ManualEN_090407 8/21/09 10:52 AM Page 1

GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES

READ ALL INSTRUCTIONS

WARNING: Read all instructions before operating product. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.

AVOID DANGEROUS ENVIRONMENTS: Don’t use appliances in damp or wet locations. Don’t use appliances in the rain.

KEEP CHILDREN AWAY. All visitors should be kept at a distance from work area.

STORE IDLE APPLIANCES INDOORS. When not in use, appliances should be stored indoors in dry, and high or locked-up place – out of reach of children.

DON’T FORCE APPLIANCE. It will do the job better and with less likelihood of a risk of injury at the rate for which it was designed.

USE RIGHT APPLIANCE. Do not use the appliance for any job except that for which it is intended.

DRESS PROPERLY. Do not wear loose clothing or jewelry. They can be caught in moving parts. Rubber gloves and substantial, non-skid footwear are recommended when working outdoors. Wear protective hair covering to contain long hair.

USE SAFETY GLASSES AND OTHER SAFETY EQUIPMENT. Use safety goggles or safety glasses with side shields, complying with applicable safety standards and, when needed, a face shield. Also use face or dust mask if operation is dusty. This applies to all persons in the work area. Also use a hard hat, hearing protection, gloves, safety shoes and dust collection systems when specified or required. Safety glasses or the like are available at extra cost at your local dealer or Black & Decker Service Center.

DON’T ABUSE CORD. Never carry appliance by cord or yank it to disconnect from receptacle. Keep cord from heat, oil, and sharp edges.

DON’T OVERREACH. Keep proper footing and balance at all times.

DISCONNECT APPLIANCES. Disconnect the appliance from the power supply when not in use, before servicing, and when changing accessories such as blades and the like.

AVOID UNINTENTIONAL STARTING. Don’t carry plugged-in appliance with finger on switch. Be sure switch is off when plugging in.

ELECTRICAL FAULT CIRCUIT INTERRUPTOR protection should be provided on the circuits or outlets to be used. Receptacles are available having built in electrical fault circuit interruptor protection and may be used for this measure of safety.

USE OF ACCESSORIES AND ATTACHMENTS. The use of any accessory or attachment not recommended for use with this appliance could be hazardous.

Note: Refer to the accessory section of this manual for further details.

STAY ALERT. Watch what you are doing. Use common sense. Do not operate tool when you are tired.

CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated elsewhere in this instruction manual. Have defective switches replaced by authorized service center. Do not use tool if switch does not turn it on and off.

DO NOT OPERATE portable electric tools near flammable liquids or in gaseous or explosive atmospheres. Motors in these tools normally spark, and the sparks might ignite fumes.

OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only extension cords intended for use outdoors and so marked.

EXTENSION CORDS. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The accompanying table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.

1

Image 2
Contents START-IT450 AMP JUMP-STARTER AIR Compressor VEA EL Español EN LA ContraportadaGeneral Safety Warnings and Instructions for ALL Appliances Read ALL InstructionsSafety Guidelines / Definitions Never Attempt to JUMP-START or Charge a Frozen Battery Features IntroductionCHARGING/RECHARGING Controls and IndicatorsApplications AIR Pressure Gauge Charging AdapterJUMP-STARTER Viewing Battery Charge StatusVolt AC Charging Method Inflating Tires or Products With Valve Stems Care and MaintenancePortable Inflator Inflating Other Inflatables Without Valve StemsBattery Disposal AccessoriesService Information Battery Replacement/Disposal Full TWO-YEAR Home USE WarrantyConserve Este Manual Para Futuras Consultas LEA Todas LAS Instrucciones Advertencia Riesgo DE Descarga Eléctrica Voltios Longitud total del cable en piesAdvertencia Riesgo DE Gases Explosivos Introducción Advertencia Para Reducir EL Riesgo DE LesionesUsos CaracterísticasControles e indicadores PicosEstado de la carga de la batería de la visión CARGA/RECARGARMétodo de carga de la CA de 120 voltios Puente Auxiliar DE ArranqueCompresor DE Aire AdvertenciasAccesorios Cómo inflar neumáticos o productos con vástagos de válvulasCuidado Y Mantenimiento Información del servicio técnicoGarantía Completa DE DOS Años Para USO EN EL Hogar Reemplazo/Eliminación de la bateríaEliminación de la batería Especificaciones