Ramsey Electronics LEAD ACID BATTERY CHARGER KIT manual Adjusting Your LABC1 Battery Charger

Page 17

ADJUSTING YOUR LABC1 BATTERY CHARGER

Now that you have finished the assembly stage there is only one more step before you start charging your batteries. The necessary alignment is to adjust R2 for the proper ‘Float’ voltage with reference to the current air temperature around diodes D5 to D14. In order for the temperature compensation network to function properly and automatically adjust the ‘Float’ voltage as needed, you will need to know the air temperature in the room you are in. Note that this adjustment only needs to be done once. When R2 has been set, the unit will automatically track as needed from there on out.

To adjust R2, take a temperature reading for the current room temperature with a thermometer. Set your voltmeter on the 20VDC scale and attach the probes (Red = +, Black = -) across the output of J2. Trim the pot (R2) to get a reading of 13.4 VDC (+- 0.01 VDC) at a room temperature of 25°C (77°F) with no battery attached. If your room temperature is above or below 25°C, you will need to account for the difference by offsetting the alignment voltage by 22mV (10 x 2.2mV/°C for each of the sensor diodes) for every 1°C of difference. See Table 2 for examples.

If you do need to adjust for any temperature differences, here are a few helpful hints to point you in the right direction:

·If the temperature is higher than 25°C (77°F), reduce the alignment voltage at J2 by 22mV for each 1°C difference.

·If the temperature is lower than 25°C (77°F), increase the alignment voltage at J2 by 22mV for each 1°C difference.

Handy formulas: °F = (°C x 1.8) + 32 or °C = (°F – 32) x 0.556

Table 2.

‘Float’ Mode voltage settings of R2 for

different example temperatures

Temperature

J2 Terminal Voltage

 

12V Battery

 

 

27°C (81°F)

13.356 VDC

 

 

25°C (77°F)

13.400 VDC

 

 

23°C (73°F)

13.444 VDC

 

 

LABC1 • 17

Image 17
Contents Lead Acid Battery Charger KIT Ramsey Transmitter Kits Lead Acid Battery Charger KIT Quick Battery Theory State Specific Open Circuit Description LABC1 LABC1 LABC1 Parts Layout Diagram Capacitors Parts Supplied with Your LABC1 KITResistors and Potentiometers Semiconductors and Integrated CircuitsEnough of that ... let’s get started LABC1 Battery Charger KIT Assembly LABC1 1 3 3 B a c k Front View Front View after Bending Assembly Instructions for Custom Case Temperature J2 Terminal Voltage Adjusting Your LABC1 Battery ChargerSafety Considerations LABC1 Hints Troubleshooting GuideConclusion This page intentionally left blank Ramsey Kit Warranty Additional Suggested Items Required ToolsRamsey ELECTRONICS, INC Fishers Station Drive Victor, New York